titanium foundry casting titanium and titanium alloy pressure

Good melting of titanium with a certain degree of superheat liquid by turning the crucible, casting by pouring cup was sent to the room, under the effect of pressure die-casting rod, casting type liquid titanium foundry into the cavity from the casting room, die casting good at casting type inner packing, cooling, and then removed. To eliminate casting surface may produce cold traps, flow marks or other defects due to cast, especially the thin edge. Die-casting should be preceded by the type of warm-up. Arc melting is used as a heating source, in addition, a vacuum aerospace titanium may also be used in induction heating, electron beam heating, or the suspension smelting. Heat-resistant steel casting-type material used in severe erosion by liquid titanium foundry molybdenum or special places may be inlaid graphite block. Casting chamber die casting machine uses heat-resistant alloy. Pressing the piston head with a molybdenum alloy or heat-resistant alloy. Type casting surface roughness should not be less than Ra≈0.6μm, otherwise, it should affect the surface quality precision castings. To improve the life of the mold and die casting part, a lubricant may be sprayed on their work surface.